The SK-720 is one of the most advanced and full-featured helicopter controllers available today, ready for beginners and professionals alike. Combine it with the SK-GPS2 module, and you have a powerful auto-rescue and aerial photography system for single-rotor, tandem-rotor, or multirotor helis.
$249.00 (usd) – This Week Only
The SK-GPS Version 2 is designed to maximize solid signal reception as priority #1. It has a huge 35mm patch antenna, double filtering, is fully shielded against RFI, and uses the latest ublox GPS chipset with a 10hz update rate.
In a single unit, the SK-GPS combines altitude and position hold, and a flight floor and ceiling that works in both single rotor and multirotor helis, and even inverted! The SK-GPS will work with any SK-720 with current firmware and is a great system for any pilot, from beginners to commercial aerial photographers!
The SK 540 is our next-generation flybarless system, ready for any pilots wanting no-frills, rock solid flybarless control. The SK 540 features 3D Masters-proven flight control, dual 3-axis MEMS gyros, and an integrated governor. Whether you’re new to helis or you’re already flying smack 3D, the SK 540 is ready for you!
The SK540 Clear takes the 3D-competition-proven SK540 and packages it into Skookum Robotics’ most affordable flybarless controller ever!
The SK-Plot Data Viewer’s trial version is a free download but the Pro version can do much more. With the purchase of a low cost license, you can also view radio link logs, gyro event logs, and printable plots of many of the inputs and sensors of the SK-720.
The SK-LCD Field Terminal allows you to set up your SK-720 at the field, without a laptop computer. It will give you access to all thefunctions of the PC-based GUI, except upgrading the SK-720’s firmware.
The SK-LED Remote Indicator Light plugs into the SK-720, to extend the unit’s status LED so it’s visible outside of the canopy. Especially useful for scale helis.
The SK-SB1 S-Bus adapter allows you to connect a Futaba S-Bus capable receiver directly to the older “blue” SK720, giving full high-speed digital access to up to 11 channels. Note, this item is not required for the sk-540 or the Sk-720BE!
The SK-CBL is a cable-tree set that lets you easily connect any traditional (PWM servo outputs) receiver to the SK-720.
High power servos draw a lot of current – a set of four 8717 servos can often be pull 12 amps! The SK-PB1 Power Bus was designed for up to 20 Amps of continuous current, and helps isolate the SK-720 from vibration.
The SK-PB2 is a new version of the SK-720’s high-amp servo power bus designed for use with direct 2S lipos, which includes a built-in ‘soft switch’ feature. This fail-safe FET switch lets you turn the heli’s servo rail power off from outside of the canopy.
The SK-PL1 anti-vibration kit includes 6 vibration-damping pads, 3 thin-pads, and a metal plate to help damp vibrations on nitro helis, or any electric heli that runs a little rough.
The SK-360 was our first flybarless unit, released back in 2007. It was discontinued in 2010 with the release of the SK-720.